The process for changing an EBSP200 PID from Farenheight or Celsius to the opposite is as follows:Press SET and < at the same time, PASS will appearEnter 0101 and press SET, INPT will appearPress SET until you see UNITPressing the UP/F2 or DOWN/F1...

The process for changing an EBSP200 PID from Farenheight or Celsius to the opposite is as follows:<ol><li>Press SET and &lt; at the same time, PASS will appear</li><li>Enter 0101 and press SET, INPT will appear</li><li>Press SET until you see UNIT</li><li>Pressing the UP/F2 or DOWN/F1 keys, you can change from F to C or C to F depending on your desired unit.</li><li>Press SET again to save</li><li>Then press SET and &lt; to return the Present and Set value display.</li></ol>Panels assembled will typically ship setup for Farenheight but PIDs shipped as parts will ship in Celsius.Check out the following video for demonstration:<div class="hd--embed" data-provider="YouTube" data-thumbnail="https://i.ytimg.com/vi/BfGP-rdAOOU/hqdefault.jpg"><iframe allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen frameborder="0" height="113" src="https://www.youtube.com/embed/BfGP-rdAOOU?feature=oembed" width="200"></iframe></div>

Changing EBSP200 from F to C

On occassion, a user may need to replace a PID. Whether this is for a software malfunction, software configuration glitch or a bad chip on the unit would be tested for. As to repairing the PID, reach out us as we offer 90 days full swap...

On occassion, a user may need to replace a PID. Whether this is for a software malfunction, software configuration glitch or a bad chip on the unit would be tested for. As to repairing the PID, reach out us as we offer 90 days full swap warranty.For a quick swap, the good news is no wires need to be removed to accomplish this task.In the even you have to swap out the PID, as long as the wiring isn&apos;t the problem, the repair is very simple and only needs a flat head screw driver or razor to make it simple to swap.On each side of the PIDs front bezel, you will find a notch. This notch is a finger grab.<figure><img src="https://files.helpdocs.io/d646s7ogz2/articles/4iuvqozrqu/1620669746494/img-2998-jpg.JPG"></figure>Using your fingers, or for better luck, use a razor edge on the corner. Pulling forward and out.<figure><img src="https://files.helpdocs.io/d646s7ogz2/articles/4iuvqozrqu/1620669832755/img-2999-jpg.JPG"></figure>Swap out and gently push in the new unit.You will need to update your PID configuration such as alarms, input type, and units on power up.Video demonstration:

Electric Brewing Supply PID Control

Changing EBSP200 from F to C

Swapping out an EBSP200